Home / Services
Services

Concrete driveway & flatwork services in Marysville

Driveway replacement, new pours, sidewalks, patios, and section repairs — residential flatwork only.

Flatwork onlyDriveways, walks, patios, aprons
Base & thickness upfrontOn the estimate, not in fine print
Cure timeline at the pourFinish options and traffic rules
Free estimatesMeasured scope before any sawcut
What we do

Five flatwork services

Every estimate spells out base, thickness, joints, and finish before we schedule a pour.

Home with a wide concrete driveway and two-car garage

Concrete driveway replacement

For drives that are past patching.

  • Sawcut / breakout of failed slabs
  • Regrade and compact the base before the new pour
  • Control joints laid out for slab size and load
  • Apron transition matched to the garage slab when possible
Fresh concrete being leveled with a power screed

New driveway pours (builds & widenings)

New drives, extra parking, and widened approaches.

  • Layout for single- or double-car configurations
  • Thickness recommendations for passenger vs occasional truck use
  • Slope for drainage away from the garage
  • Permit guidance is informational — homeowner / GC files unless contracted
Row of homes with concrete driveways and walkways

Sidewalks, paths & curb aprons

The walks between the street, the drive, and the door.

  • City-adjacent walk repair (right-of-way rules confirmed before we bid)
  • Side-yard paths and trash-bin pads
  • Curb cut / apron work where allowed
  • Trip-hazard section replacements when the budget is staged
Power trowel finishing a freshly poured concrete slab

Patio & outdoor slab flatwork

Outdoor slabs built for how you’ll use them.

  • Patio slabs sized for furniture or covered areas
  • Broom or smooth finishes per use
  • Step / landing pours tied to existing elevations
  • Concrete surface only unless an outdoor kitchen is scoped separately
Hand trowel smoothing fresh concrete at a form edge

Remove-and-replace problem sections

When most of the drive is sound.

  • Isolate heaved or tree-root damaged panels
  • Partial replacement when the rest of the slab is sound
  • Root barrier discussion (a landscaper may be needed)
  • An honest call when full replacement is smarter
Straight answers

What we do — and what goes to another trade

Included in a flatwork estimate

  • Measurements and a written scope
  • Base and thickness recommendation
  • Joint layout and drainage slope discussed
  • Finish options (broom or smooth)
  • Cure and traffic timeline given at the pour

Out of scope for us

  • Foundation repair or crack injection
  • Structural slabjacking or crawlspace jacking
  • Commercial warehouse floors
  • Asphalt paving (we may refer you out)
  • Stamped / decorative concrete as a primary job
How it works

Three steps to a new slab

Measured, scoped, and poured around the weather.

01

Describe the project

Call or send the form with rough dimensions, the current surface, and photos of the worst sections.

02

Measured estimate

We confirm dimensions, base, thickness, joints, and finish — then book a pour date around the forecast.

03

Tear-out & pour

We break out, prep the base, pour, and finish — then give you the cure and parking timeline.

Not sure if it’s a patch or a replacement?

Send photos of the worst sections — we’ll tell you honestly which category you’re in.